Self-Powered Kinetic Wall Switch, IP54, 95-260 V Receiver

A kinetic wall switch that needs no cable and no battery: press the panel and it sends a 433.92 MHz signal to the receiver, which switches the light. The receiver takes 95-260 V AC. It suits sheds, garages and outbuildings where pulling a switch wire is awkward.

Control a light where cable cannot go

✅ No cable to the switch. The panel makes its own power from the press, so no wire and no battery is needed behind it.

✅ Fix it where the wire cannot reach. Mount the panel on a shed wall or door frame and the receiver sits at the light instead.

✅ Switches from across the yard. Range is over 200 m in open ground and over 50 m indoors, so the light answers from the far gate.

✅ Runs the load you already have. The receiver switches up to 1500 W resistive or 1200 W inductive and capacitive loads at 95-260 V AC.

✅ Fits a porch or garage wall. The switch panel carries an IP54 rating for a wall where dust and splashes are part of the day.

Technical details

• Switch type: push button, self-powered
• Frequency: 433.92 MHz
• Switch panel size: 86 x 88 x 15.5 mm
• Protection rating: IP54, switch panel
• Receiver voltage: 95-260 V AC
• Load: 1500 W resistive, 1200 W inductive or capacitive
• Range: over 200 m open ground, over 50 m indoors
• Button life: over 200,000 presses
• Variants: 19
• Pairing: panel and receiver must be used together and will not pair with other remotes or switches

Key specs: Switch type: push button, self-powered · Frequency: 433.92 MHz · Switch panel size: 86 x 88 x 15.5 mm

Fit the panel by the door and put the receiver at the light you want to control.