Desk-Clamp Overhead Phone Stand with Adjustable Boom Arm
Film a drawing, craft step or tabletop demonstration without holding the phone above your work. This desk-clamp stand positions a compatible phone holder on an adjustable boom arm. It is for creators who want an overhead view from a suitable table edge.
- ✅ Keep hands in the demonstration — The boom can position a phone over the work while you draw or make something.
- ✅ Leave the centre of the desk open — The edge clamp places the upright beside the working area rather than on a wide base.
- ✅ Reframe without moving the whole table setup — The boom slides and changes angle at the central joint.
- ✅ Adjust the filming height — The telescopic upright gives a choice of positions above a suitable desk.
- ✅ Choose an overhead or angled view — The arm and holder joints offer different camera approaches to the tabletop.
Build the frame around your tabletop activity
Clamp the stand to a suitable, secure table edge and check the hold before adding a phone. Adjust height, arm extension and angle, then retighten each joint before recording. Keep the phone over a stable area and check balance before releasing it.
The illustration marks an approximately 35–55 cm upright range and 1/4-inch threaded connections. A phone holder is shown with the assembly, but its exact opening range and the stand's load rating are not confirmed. Check the handset and case fit rather than assuming every phone or camera is suitable.
One black desk-clamp stand assembly is supplied; the phone, table and demonstration items are not included. It is not a freestanding tripod. The opposite arm end is visible, but a counterweight is not confirmed as supplied and the arm should not be treated as suitable for an unrestricted camera load.
The upright is illustrated at approximately 35–55 cm, with marked 1/4-inch connection points.
An overhead position can keep the hands and tabletop activity in frame.
Clamp to a suitable edge and tighten the adjustments before fitting a phone.
Sliding the boom changes the reach; recheck the balance after adjusting it.
Choose the angle, then secure the central joint before recording.
The table edge carries the stand; the drawing and desk are use examples.
The opposite arm section is not confirmation of an included counterweight.
Technical details
- Item: desk-clamp stand with adjustable boom
- Colour: black
- Illustrated upright range: approximately 35–55 cm
- Connections: marked 1/4-inch threads
- Adjustments: height, boom position and boom angle
- Mounting: table-edge screw clamp
- Phone holder: shown with assembly; opening range not confirmed
- Load rating: not confirmed
- Included: 1 stand assembly; phone and table not included
- Power: none required
Check your desk and phone fit, then set up a tabletop recording view that leaves your hands free to demonstrate.
Válasszon opciókat