Filament-run-out-sensor van 1,75 mm met 1 m kabel

Detect the presence of 1.75 mm filament with a run-out sensor and 1 m connection cable for a compatible 3D printer.

Monitor filament in a compatible printer

• ✅ Monitor filament presence – The sensor changes its signal when filament is no longer detected.
• ✅ Connect the sensor to a suitable board – The supplied cable provides the listed connection to a compatible controller.
• ✅ Configure a run-out response – Compatible printer firmware can use the signal to trigger a pause when properly set up.

Verify voltage, pinout, signal behaviour and firmware support before installation. Automatic pausing depends on the printer configuration and is not guaranteed by the sensor alone.

• Specifications: 1.75 mm filament; approximately 1 m cable; selected black or white housing. Package: one sensor and one cable.

Check the board pinout and firmware support before fitting the sensor. Explore more 3D-printer accessories.