Push-Pull On/Off Switch for DC Circuits

Add a simple push-pull control to a compatible low-voltage DC circuit. The metal body and screw terminals provide a separate switching component for an appropriately designed vehicle or equipment installation.

• ✅ Use a straightforward two-position action - push or pull the knob for the specified switching state.
• ✅ Connect through screw terminals - match the wiring to the actual circuit design.
• ✅ Plan the panel mounting - the threaded stem gives a defined mounting arrangement.

Match the Switch to the Load and Panel

The listing describes an SPST on/off format for 6-28 V DC use. Verify the actual current rating for the intended load, including starting current, rather than assuming a headline ampere figure suits every circuit.

Check panel thickness, stem dimensions and terminal clearance. Use appropriate fusing and wiring, and have the electrical installation completed by a qualified person where required. No marine weather rating is established.

Technical details

• Type: two-position push-pull SPST switch.
• Listed system range: 6-28 V DC.
• Body: die-cast metal; copper screw terminals listed.
• Listed stem: 5/8 inch long, 15/32 inch diameter.
• Package: one switch.

Check the circuit and panel requirements before choosing the push-pull control.