Two 4-Inch F-Clamps for Woodworking and Board Assembly

Glue-ups need a third hand. These two nylon F-clamps hold a board joint or a glued edge while it sets, and the quick clip body is made for fast placement and release between steps. They suit home woodworkers, model makers and anyone assembling shelves or frames on a bench.

Hold a glue joint while both hands are busy

✅ Two clamps in one pack Two clamps arrive together, so a single joint can be held at both ends without stopping to fetch another tool.

✅ Hold the glue joint closed On a tabletop glue-up the pair holds the boards level and closed while the adhesive cures.

✅ Small work stays clear The 4 inch body suits small frames, drawers and model work, where a long bar clamp gets in the way.

✅ Open and close quickly The quick clip mechanism opens and closes fast, so you can shift both clamps along a panel between steps.

✅ Tidy in a toolbox At 4 inch the pair takes little room in a drawer or toolbox, so it stays with your other hand tools.

Work the joint in order: dry fit the pieces, spread the glue, then set one clamp on each end and check the corners for square before the adhesive grabs. The jaws carry no confirmed protective pad, so slip a scrap of card under each jaw where a finished face would otherwise be marked.

The pack holds two clamps and nothing else. No pads, case or spare parts are confirmed, and the size is given as 4 inch with no metric figure, so compare it against the joint you have in mind rather than assuming a span.

Sizing is the part worth checking first. A pair of 4 inch clamps is aimed at drawers, boxes, frames and repairs; a wide tabletop needs longer clamps, and these will not reach across the panel.

There is no battery, cable or setting to manage: the clamp works by hand, which is why it can sit in a drawer for months and still be ready when a repair comes up. The manual measurement note allows 1 to 3 mm of variation between units.

Technical details

• Pack contents: 2 x 4-inch woodworking F-clamps
• Size: 4 inch, no metric equivalent confirmed
• Body material: Nylon
• Fixing: Metal fixing clip
• Operation: Manual, quick clip
• Intended use: Woodworking, DIY assembly and repairs
• Measurement tolerance: 1-3 mm, manual measurement
• Colour: As shown; shade can vary between monitors
• Extras: No pads, case or spare parts confirmed

Keep the pair on the bench for your next glue-up, and check the 4-inch size suits the joint.

See more: explore more hand tools for woodworking and repairs