





ESP32 Dual-Relay Wi-Fi Bluetooth Development Board
✅ Switch two channels. Paired relays give separate outputs from a single board, so one build can run two circuits.
✅ Add your own inputs. GPIO and UART connections are brought out for sensors, buttons and other interfaces.
✅ Programme it in Arduino. The board is intended for ESP32 development with Arduino IDE support and onboard reset and IO0 buttons.
✅ Keep wireless options open. Wi-Fi and Bluetooth are built in, leaving the radio link to your own programme.
Two relay channels on one ESP32 board
Build a wireless control project around an ESP32 board that carries two relay channels. Wi-Fi and Bluetooth are onboard, with GPIO and UART connections brought out for your own inputs and interfaces. It is a development component, so behaviour follows the programme you load and the circuit you connect.
Technical details
- ESP32 Wi-Fi/Bluetooth development board
- Two onboard relay channels
- 4 MB flash
- GPIO and UART breakout connections
- Reset and programmable IO0 buttons
- Package: one board; programming and power source required





Start your two-channel wireless control project with the ESP32 relay board.
Choose options





