WLED Wi-Fi LED Controller Module ESP8266 with USB-C

✅ Change colours from your phone. Once on your network, the WLED interface adjusts colours, brightness and effects.

✅ Skip the first flash. WLED firmware comes preloaded, so setup starts with configuration, not flashing.

✅ Pick your power route. USB-C or the 5V/GND pads give two ways to feed a planned build.

✅ Keep the load in range. The board states a 2A power-path limit, so size the connected strip to it.

WLED control on your network, ready to configure

A Wi-Fi controller module built on an ESP8266/ESP8285 board with WLED firmware already loaded. It gives a compatible LED build a browser interface for colour, brightness and effect changes. The board offers USB-C and 5V/GND pads, with a stated 2A power-path limit.

Technical details

• ESP8266/ESP8285 module with WLED preloaded
• Wi-Fi; USB-C; CH343P USB-to-serial chip
• 5V/GND pads; stated board power-path limit: 2A
• Controller module, not a complete LED lighting kit

Add network control to a matched LED build and set it from your phone.