ESP8266 WLED Wi-Fi Controller Module

Change the look of a compatible LED project from your phone or computer. This Wi-Fi controller module comes with WLED firmware loaded, giving your lighting build a software starting point without an initial firmware-flashing step.

✅ Adjust the lighting without reaching into the build - WLED's network interface lets you change supported colours, brightness and effects from a phone or computer.

✅ Start configuration without first loading WLED yourself - Preloaded firmware removes the initial flashing task before setting up the LEDs and network.

✅ Choose a power connection that suits the enclosure - USB-C and the 5V/GND pads provide connection options for a correctly designed installation.

Set Your LED Colours From a Phone or PC

After the module is configured on your network, open its WLED interface to adjust the connected lighting. The strip type, data output and LED configuration must match the actual hardware; WLED software support does not establish every board's wiring compatibility.

Plan power before fitting the module inside a case. The board's stated power-path limit is 2A, so calculate the connected load and follow the appropriate wiring instructions rather than assuming it can supply an entire high-current strip.

Technical details

• ESP8266/ESP8285 module with WLED preloaded
• Wi-Fi; USB-C; CH343P USB-to-serial chip
• 5V/GND pads; stated board power-path limit: 2A
• Controller module, not a complete LED lighting kit

Add configurable WLED control to a correctly matched LED build.