5 V Pressure Sensor - 0 to 1.2 MPa

Bring pressure information into a compatible monitoring circuit. This 5V DC transducer converts a supported non-corrosive medium's pressure into an analogue voltage output for the receiving electronics.

✅ Read pressure through a voltage-based input - The transducer supplies the specified analogue signal for a correctly matched controller or readout.

Build the Measurement Around the Medium

Use the sensor when the project needs a pressure reference within its specified working range. The receiving circuit must interpret the output correctly, so match its input and power arrangement to the transducer before final installation.

Confirm the thread, seal and material compatibility with the actual non-corrosive medium. The sensor is a measurement component, not a complete pressure gauge or a safety relief device, and the finished system needs the appropriate mechanical and electrical protection.

Technical details

• 5V DC pressure transducer
• Specified working range: 0-1.2MPa
• Specified output: 0.5-4.5V DC
• Approx. 19cm lead; red supply, black ground, yellow signal
• One sensor; readout/controller separate
• Confirm mechanical connection and media compatibility

Match the pressure range and interface, then add the transducer to the monitoring circuit.