Hex-Shank Drill Wire Stripper, 2.5–10 mm² Options
Prepare repeated wire ends with a stripping attachment for a compatible drill. This hex-shank wire stripper uses a rotating cutting head and an adjustable stop. It is for competent users working on disconnected conductors, with a separate size choice for each stated wire cross-section.
- ✅ Prepare a run of similar wire ends — A compatible drill provides rotary motion for repeated stripping tasks.
- ✅ Set the exposed length before connecting — The adjustable stop helps repeat a chosen strip length.
- ✅ Match the head to the conductor — Separate colour-coded options correspond to stated wire cross-sections.
- ✅ Keep the setup compact — The hex shank fits a compatible drill chuck or holder.
Select by wire size, not colour alone
The option images identify Sliver as 2.5 mm², YELLOW as 4 mm², Red as 6 mm² and Blue as 10 mm². These are separate tool selections, not a set of all four. Check the supplied head marking against the conductor before use.
The adjustable stop determines how far the end enters the cutting head. Test on a spare piece of the same wire first and inspect the conductor before making a termination. Stripping results depend on the wire construction, insulation and correct adjustment.
This is an attachment, not a powered stripping machine. A compatible drill and its battery are separate. Work only on isolated, disconnected wiring and follow the tool and drill instructions.
Illustrations show several available sizes; select one option.
Adjust the stop for repeated wire-end preparation.
Check the hex shank against the drill holder.
Use the head marked for the conductor cross-section.
Dimensions illustrate the adjustable assembly; check fit before use.
The cutting head acts on the insulation of a correctly matched wire.
Several colours are shown for comparison, not an included set.
Yellow corresponds to the stated 4 mm² option.
Red corresponds to the stated 6 mm² option.
Follow the supplied fitting instructions and test on spare wire.
Technical details
- Type: rotary wire-stripping drill attachment
- Drive fitting stated: 6.35 mm hex shank
- Sliver option: stated for 2.5 mm² wire
- YELLOW option: stated for 4 mm² wire
- Red option: stated for 6 mm² wire
- Blue option: stated for 10 mm² wire
- Adjustment: wire insertion/stripping length stop
- Power: supplied by a separate compatible drill
- Package: one selected wire-stripping attachment
- Exclusions: drill, battery and wire
Choose the head that matches your wire and prepare consistent ends for the next connection.
Välj alternativ