Outdoor LED Floodlight with PIR Sensor, 20 W to 300 W

A driveway, a shed wall or a back garden goes dark early in winter. This LED floodlight is available from 20 W to 300 W in 110 V and 220 V versions, with a PIR sensor that switches it on when it picks up movement, and an IP66 body for outdoor mounting.

Light for a Yard or a Garage Wall

✅ A wide spread of light A 120 degree beam spreads wide from a wall, suiting a driveway, a yard or the side of a shed.

✅ Comes on with movement The PIR sensor switches the lamp on when something moves in front of it, rather than leaving it lit all evening.

✅ Three settings to adjust TIME, SENS and LUX set how long the lamp stays on, how easily it triggers and at what light level.

✅ Aluminium body, sealed The die-cast aluminium housing carries an IP66 rating for rain, with the note that it is not for immersion.

✅ A wattage for the space Options run from 20 W to 300 W, so a porch light and a large yard light are both covered.

The lamp is an outdoor wall type with a 120 degree beam, so a wall or a gable end gives the widest throw across a drive or a yard. Wattage is a separate decision from coverage: the low options suit a doorway or a shed, the high ones a large open area.

Voltage cannot be changed later. The 220 V version is quoted for 175–265 V and the 110 V one for 100–130 V, so check the supply at the mounting point before ordering. The two versions are not interchangeable.

Three settings shape the response. TIME decides how long the lamp stays on after it triggers, SENS how much movement it takes, and LUX the daylight level at which the sensor stops responding, so it can be set to work at dusk rather than at noon.

There is no smart control, no app and no remote. The IP66 rating covers rain and spray but not immersion in water, so the lamp is not a pond or pool fitting. A CE marking is stated; cable length and warranty are not mentioned.

Technical details

• Type: LED floodlight with PIR motion sensor
• Power options: 20 W, 30 W, 50 W, 70 W, 100 W, 150 W, 200 W, 300 W
• Voltage: AC 220 V (175–265 V) or AC 110 V (100–130 V)
• Light source: LED, included
• Luminous flux: 2000 to 82000 lm
• Beam angle: 120 degrees
• Protection: IP66, not for immersion
• Body material: die-cast aluminium
• Sensor settings: TIME, SENS, LUX
• Certification: CE

Check your supply voltage first, then choose the wattage for the area.

See more: explore more outdoor lighting